B2B Wholesale Only · No Retail OE-based matching · EXW pricing · Export packing
Technical Note

How to Identify the Right Hydraulic Cylinder Seal Kit for Your Excavator

Nov 2, 2026 · FKKPM Technical Team
How to Identify the Right Hydraulic Cylinder Seal Kit for Your Excavator

A cylinder seal kit is one of the cheapest parts on an excavator and one of the most expensive to get wrong. Wrong seals do not simply leak — they score the rod, damage the bore, and turn a two-hour workshop job into a cylinder replacement.

These are the four checks we run on every seal kit inquiry, and the same checks a workshop should run before ordering.

1. Machine model is not enough

“CAT 320” covers several generations — 320B, 320C, 320D, 320D2, 320GC — with different cylinder dimensions. Always give the full model and, if possible, the serial number prefix. The serial range tells us which production batch the machine came from and therefore which seal profile was fitted at the factory.

2. Cylinder position changes the kit

Boom, arm and bucket cylinders on the same machine are different sizes and often use different seal profiles. A kit that fits the boom cylinder will not fit the bucket cylinder. When you send a request, state the position — or send a photo of the cylinder on the machine.

3. Measure bore and rod

When the machine plate is unreadable or the cylinder has been replaced before, measurement settles it. You need the inner bore diameter, the rod diameter, and the stroke. Measure with a caliper at an unworn section of the bore, not at the point where the piston sits at rest.

Rule of thumb: if the measured bore is between two standard sizes, the cylinder has probably been re-sleeved or replaced with a non-original unit. Send photos of the gland and piston — the seal profile will identify it faster than the dimensions alone.

4. Match the seal profile and material

Two kits can have the same outside dimensions and still fail: the difference is the profile (U-cup, V-packing, step seal, buffer seal) and the compound. NBR is standard for mineral oil at normal temperatures. PU gives better extrusion resistance at high pressure. PTFE is used where friction and heat are the limiting factors.

If the machine works in high ambient temperature — mining in Peru, road construction in the Middle East — tell us. The correct compound costs the same and lasts considerably longer.

What to send us

  • Machine brand, full model and serial prefix
  • Cylinder position: boom, arm or bucket
  • OE number, if you have it
  • Photos of the nameplate, the cylinder and the old seals
  • Quantity and required date

With those five items we can confirm the kit and quote the same day in most cases. Without them, any supplier is guessing — and a guess is what causes a workshop to lose a day.

Need this part quoted?

Send the machine model and quantity on WhatsApp — we confirm the match and reply within 12 working hours.

WhatsApp